How to configure vSpace to scan terminals in other subnets
Our vSpace Console is equipped with a feature that allows it to be programed to include other subnets in the network than the local one.
You can configure it by calling the vSpace Console, then Manage Devices > Networks > + > [add IP range to be discovered].
This feature does not overcome the need to configure properly your security for the allowance of our protocol across subnets. For reference on security configuration, please check this article:
If you are doing a WAN deployment please be aware of this article:
REV. 09/2019
Related Articles
vSpace Console Crashing when launched or scanning devices in the network.
We are monitoring rare occurrences in which the vSpace Console crashes. When launched or when scanning devices. One particular issue related to the firmware of the present devices is what is addressed in this article. The issue has been seen in ...How to use ‘Subnet Tags’ to assign devices to groups in PMC
Increasingly, the endpoint deployments happen outside of corporate networks. PMC Endpoint Management supports the concept of ‘Subnet tags’ to further differentiate device groups when managing devices across public Internet (i.e., not within ...vSpace Pro Installation - Tips, References and Process Detail
Published The following article is a detailed process and tips for installing our vSpace Pro platform (vSpace Pro LTS, vSpace Pro Enterprise Edition). As an additional supplement, this article will deal with all other aspects of Pre-Deployment and ...vSpace Pro Software Clean Re-Install Procedure
About this document This document will walk you through a reinstallation of vSpace Pro software. Pay attention to hyperlinks to referenced information. Review before you begin... 1. Installation should take about 15 minutes for experienced users. ...VERDE VDI Network Troubleshooting - Navigate via Table of Contents.
Product Line: VERDE Introduction: The information contained within this document refers to the networking aspects of the VERDE VDI software solution being installed via a set of RPMs (program modules) on top of CentOS7. The following networking ...