How to configure Ethernet setting in RX-RDP and RX300?

How to configure Ethernet setting in RX-RDP and RX300?

Please refer to RX300 & RX-RDP user configuration guide for additional details:  https://support.ncomputing.com/portal/kb/articles/rx300-rx-rdp-user-configuration-guide


By default the Ethernet interface is enabled and configured to obtain the IP parameters from a DHCP server.

Following Ethernet interface parameters are configurable:

·         Enable Ethernet interface – enables the interface when the check-box is selected and disables it otherwise.

·         IP Configuration – DHCP or Static. With DHCP selected the IP address, network mask, the address of default gateway, the addresses of DNS servers, as well as the default DNS domain search suffix will be obtained from a DHCP server. With Static selected the above parameters can be specified manually.

·         Address – the static IP address.

·         Network mask – the static network mask.

·         Default gateway – the static default gateway.

Hovering the mouse pointer over the Ethernet icon located in the upper-right corner of the screen displays current IP address of the Ethernet interface. The state of this icon provides additional information for the Ethernet interface:

·         Absent icon – Ethernet interface is disabled.

·         Icon with green dot – Successful Ethernet connection.

·         Icon with yellow dot – Ethernet connected, but no IP address obtained from DHCP.

·         Icon with red dot – Ethernet interface is enabled, but the cable is disconnected.


    • Related Articles

    • RX300 / RX-RDP USB Peripheral device redirection recommendations.

      Please refer the KB article on How to configure USB peripheral device redirection policy for RX300 and RX-RDP: https://support.ncomputing.com/portal/kb/articles/how-to-configure-usb-peripheral-device-redirection-policy-for-rx300-and-rx-rdp In ...

    • Can RX300/RX-RDP/RX-HDX work with PoE?

      There is a way to make RX300(or RX-RDP, RX-HDX) works with Power over Ethernet. Active PoE Splitter available from Amazon which is much cheaper and easier than Raspberry Pi PoE Hat circuit.  For example, below is the picture of typical Active PoE ...

    • Configuring RX-300 for VERDE

      Product Line:  VERDE RX300 For those of using the RX300 we have a new firmware drop, please update the firmware on your RX300. http://www.zeropc.com/rx300/rx300-3.2.25.upd http://www.zeropc.com/rx300/rx300-3.2.27.upd   ...

    • Configure RDP client as local custom application(s)

      On LEAFOS and RX420(RDP) devices (with firmware version 3.7.3 or higher), the native RDP client can be configured as a local custom application to allow users to access multiple instances of RDP server hosts, or other local applications (e.g. ...

    • How can I update firmware for RX-RDP, RX-RDP+, RX420(RDP) and LEAF OS devices?

      Please refer to RX-RDP, RX-RDP+, RX420(RDP), RX300 and LEAF OS user configuration guide for additional details:  https://support.ncomputing.com/portal/kb/articles/rx300-rx-rdp-user-configuration-guide The Support section of Setup GUI contains ...