connection ended unexpectedly

Error > can't establish connection to server connection ended unexpectedly

Using vSpace Pro on a Client Operating system, if you receive the error

can't establish connection to server


You likely have installed vSpace without Properly Elevated Permissions


if you view Windows System Event logs using Event Viewer (command prompt eventvwr.msc /s)

Look in >Windows Logs>System - Look or search for Event


    Event ID: 7000 - Source: Service Control Manager Time: 12/22/2016 @ 15:31:42
    The UTSA/UTMA Virtual Transport Driver service failed to start due to the following error: Windows cannot verify the digital signature for this file. A recent hardware or software change might have installed a file that is signed incorrectly or damaged, or that might be malicious software from an unknown source. 

 


This means you did not have proper permissions when installing vSpace


You need to run the installer from an Elevated Command Prompt




Navigate to the directory where the vSpace Installer is located and enter this command:


Run command > msiexec / vSpace_Pro_FileName.msi

If this fails, this other command is available: 

Run command > msiexec /i vSpace_Pro_FileName.msi






    • Related Articles

    • VERDE User Side Error Codes

      Product Line:  VERDE If we talk about the VERDE VDI client mode then we need to distinguish between two types of communication: User authentication and enumeration of VERDE VDI desktops. Terminal connections to VERDE VDI desktops.   The RX-series GUI ...
    • vSpace License Server is Offline. Connection is not possible

      vSpace License Server is offline.  Connection is not possible This is an error message that may be presented to Users when connectivity between the vSpace server (Session host) and the vSpace Manager has been interrupted for an extended period of ...
    • Install vSpace Pro 10 Via Elevated Command Prompt

      vSpace 10 is no longer available, nor supported. However, for a best article on how to do this procedure on current versions of vSpace Pro, please visit this article:  ...
    • L Series: Error: "Terminal server yet not ready, please retry attempt a bit later"

      If you use a L Series Legacy Device (L100, L110, L120, or L200) device, these are outdated, need to be upgraded and because of their age may have little or no support available.  Models L130 and L230 are more recent legacy products and will connect ...
    • Windows Server 2008 R2: Remote Desktop Licensing Server Configuration

      About this article This will be a helpful guide to assist you with setting up your licensing server. When setting up a Microsoft Windows, Server Operating System, you will see the requirement of configuring an activate a Licensing Server within a ...